




Caterpillar 324EL
47 900EUR
Price excl. VAT
- ≈ 7 065 250 KES
- ≈ 54 733 USD





Caterpillar 324EL
69 000EUR
- ≈ 10 177 500 KES
- ≈ 78 844 USD





Caterpillar 324 EL
59 600EUR
- ≈ 8 791 000 KES
- ≈ 68 103 USD





CAT 324EL





Caterpillar 320EL





Caterpillar 324 EL Gravemaskin - Skuffe, tilt og GPS
49 500EUR
- ≈ 7 301 250 KES
- ≈ 56 562 USD





Caterpillar 324
92 450EUR
Price excl. VAT
- ≈ 13 636 375 KES
- ≈ 105 639 USD





Caterpillar 324
92 450EUR
Price excl. VAT
- ≈ 13 636 375 KES
- ≈ 105 639 USD





Caterpillar 324
92 450EUR
Price excl. VAT
- ≈ 13 636 375 KES
- ≈ 105 639 USD





CATERPILLAR 324
78 857EUR
- ≈ 11 631 407 KES
- ≈ 90 107 USD
Crawler excavator Caterpillar 324 EL
See similar
We have other ads similar to this offer
See what's in stock now
The seller didn't indicate the price
This ad is stored in the archive for reference (specifications, typical price). There are no outdated ads on the site — all active options can be found below.
- 26,5 ton - Engcon Rotortilt
- Propellant: Diesel
- Catalyst: Yes
- Boom type: Mono boom
- Hydr. Quick hitch on dipper: S70
- Tiltrotator: Engcon w/grab arm
- Hydr. quick hitch below tiltrotator: S70
- Bucket cm: 160
- Wide bucket cm: 220
- Track type: Steel
- Undercarriage % good: 60
- Transport dim. (L x W x H) m: 10.20 x 3.40 x 3.25
- Is visually reviewed, but not fully tested in all functions: Yes
- Pin & Bush in stick boom bucket OK: Yes
- Engine oil OK: Yes
- Engine OK: Yes
- Turbo OK: Yes
- Might be in operation until delivery: Yes
- Technical condition (1-5) 5=best: 3
NB: The machine is sold at auction without the Leica3D GPS system , as shown in the pictures - but the Leica system can be purchased in addition to the bid price by paying DKK 50,000 / EURO 6,750!
The machine has hydraulic quick-change both above and below the Engcon rotor tilt - and thus the operator of the machine can easily take the rotor tilt off and on as needed.
The ECM engine control has been replaced with a new one only 500 hours ago - and the particle filter was changed approx. 750 hours ago.
Approximately 3000 hours ago, all joints between boom and boom foot, between lifting cylinders and boom foot, between boom and arm have been flush drilled/welded and new pins and bushings have been installed. The tiltrotor has also been renovated with new piston rods in the grab (claw).
See more pictures and information - as well as other auctions at www.fymasauctions.dk Caterpillar 324 EL - 26,5 ton - Engcon Rotortilt
This offer is for informational purposes only. Please confirm details directly from the seller.
The seller didn't indicate the price
This offer is for informational purposes only. Please confirm details directly from the seller.










